Maytag one next to the other fridge and some top mount cooler’s have a typical issue. In the event that your model has a versatile thaw out control board it is presumably terrible, lets test and find out. You will require a volt meter to confirm what part is terrible.
At the point when the coolers versatile thaw out control fizzles, the fridge never goes into thaw out, subsequently causing a development of ice on the evaporator loops. At the point when the ice develop happens it slices the wind stream off to the cooler segment. The evaporator fan can not get air through the evaporator and drive it into the fridge area.
On the Maytag style next to each other beginning by eliminating the back board and thawing out the top portion of the evaporator. The back board is held down with two screws once eliminated the lower back board will lift out. This will empower you to make the appropriate test at the warmer and thaw out indoor regulator.
When inside the cooler compartment you should separate the warmer and indoor regulator wires. This is the very thing the two sections should ohm out at.
-Thaw out warmer (30 ohm)
-Thaw out indoor regulator (Short of what one ohm)
In the event that both of these parts refrigeration contractors test inside spec, the versatile thaw out control board is the shortcoming.
The versatile thaw out control is situated in the fridge segment in the light lodging. You should eliminate the lodging to get to the versatile thaw out control. This is the way to do as such.
Eliminate the plastic lodging cover the controls. On the rear there are two finger grooves, place pressure downwards and pull forward the plastic lodging will slide forward and out.
Presently there are two screws that hold the reasonable plastic temperature pointer eliminate them, straightforwardly behind and alongside the light there are two additional screws eliminate them. On the back center of the lodging you will see another screw, by eliminating it the lodging will descend delighting the versatile thaw out control board.
On some model the control is held down with two screws, in the event that your model is more up to date or the control has proactively been supplanted, the board will lift out of the lodging. Take the wire outfit of the control and introduce the new board.
You should thaw out the cooler segment and clear all of the ice prior to reestablishing the fridge back to ordinary activities. Not clearing the ice won’t bring about the unit ever returning to temperature and conceivable loss of food.